Representative Image
Exhaust Check Valves (KF Flanged)
These simple check valves help prevent air in rush into a system after powering down the rough pump. Typically installed on the exhaust side of the roughing pump they can prevent oil back streaming upon pump shut down or failure. Uses either a gravity sealed elastomer ball for traditional vertical installations or a spring-loaded O-ring sealed disc for installation in any orientation.
Merkmale
- 316 Stainless Steel body with FKM Seals
- Minimum relief pressure of 7mbar
- Leak rate: 1x10-5 mbar-L/sec
- Recommended in operating conditions where air in rush could pull particulates back into the system
- Reduces oil back streaming from wet pumps
- Temperaturbereich: -5°C to 100°C (approx.)
Spezifikationstabelle
| Hersteller | KJLC |
|---|---|
| Druck |
Torr 7,500 x 10-5 Torr mbar 1,000 x 10-4 mbar |
| Rates |
Leckrate 1,000 x 10-5 mbar*L/s 7,520 x 10-6 Torr*L/s Minimum Relief Pressure 7,00 mbar 5,25 Torr |
| Temperatur |
Bakeable 100 ºC 212 ºF |
|
Valve Body Werkstoff |
316L SS
|
|
Valve Seal Werkstoff |
Viton
|
X CLOSE
Bestelltabelle
(Klicken Sie auf die Spaltenüberschriften, um die Daten zu sortieren.)
CloseX
CloseX